2MW/2MX
1-3-106
U935 Relay board maintenance
Description
Sets the mode when call for service (C0060) occurs.
Purpose
Sets the machine status temporarily when call for service (C0060) occurs. However, after the set-
ting, call for service (C0060) occurs again when progress of period.
Setting
1. Press the start key.
2. Select [Mode].
3. Change the setting using the cursor left/right keys.
* : Initial setting: Mode0
4. Press the start key. The setting is set.
5. Turn the main power switch off and on.
Supplement
After removing the cause of the problem, be sure to change the setting in OFF.
Item No. Description
Display Description
Mode0 Setting mode: OFF
Mode1 Setting mode: ON (Usable up to three times of use)
To Next Page
Loading...
