Kyocera FS-6525MFP - Detaching and Refitting the High Voltage PWB

2MW/2MX
1-5-37
5. Remove four FFCs from the operatioon
panel PWB main.
6. Remove four screws and then remove
the operation panel PWB main.
7. Check or replace the operation panel
PWB main and refit all the removed
parts.
Figure 1-5-64
(5) Detaching and refitting the high voltage PWB
Procedure
1. Remove the rear cover, inner tray and
eject rear cover.
(See page 1-5-5,1-5-6 and 1-5-8)
2. Remove the FFC from the high voltage
PWB.
3. Remove four screws and then remove
the high voltage PWB.
4. Check or replace the high voltage PWB
and refit all the removed parts.
Figure 1-5-65
Screw
Screw
Screw
Screw
FFCs
Operation panel
PWB main
Screw
Screw
Screw
Screw
High voltage PWB
Connector(back side)
FFC
High voltage
PWB