Kyocera FS-6525MFP - Page 173

2MW/2MX
1-4-11
1900 Paper feeder EEPROM error
When writing the data, the
write data and the read data is
not continuously in agreement
5 times.
Defective PF main
PWB.
Replace the PF main PWB (Refer to the ser-
vice manual for the paper feeder).
Device damage of
EEPROM.
Contact the Service Administrative Division.
2000 Main motor steady-state
error
Stable OFF is detected for 1 s
continuously after main motor
stabilized.
Defective connec-
tor cable or poor
contact in the con-
nector.
Reinsert the connector. Also check for conti-
nuity within the connector cable. If none,
replace the cable.
Main motor and engine PWB (YC16)
Defective drive
transmission sys-
tem of the main
motor.
Check if the rollers and gears rotate
smoothly. If not, grease the bushes and
gears. Check for broken gears and replace if
any.
Defective main
motor.
Replace the main motor.
Defective engine
PWB.
Replace the engine PWB and check for cor-
rect operation (see page 1-5-35).
2010 Main motor drive error
The main motor is not stabi-
lized within 2 s after driving
starts.
Defective connec-
tor cable or poor
contact in the con-
nector.
Reinsert the connector. Also check for conti-
nuity within the connector cable. If none,
replace the cable.
Main motor and engine PWB (YC16)
Defective drive
transmission sys-
tem of the main
motor.
Check if the rollers and gears rotate
smoothly. If not, grease the bushes and
gears. Check for broken gears and replace if
any.
Defective main
motor.
Replace the main motor.
Defective engine
PWB.
Replace the engine PWB and check for cor-
rect operation (see page 1-5-35).
2600 PF drive motor error
(paper feeder)
When the PF drive motor is
driven, error signal is detected
continuously for 2 s.
Defective connec-
tor cable or poor
contact in the con-
nector.
Reinsert the connector. Also check for conti-
nuity within the connector cable. If none,
replace the cable.
PF drive motor and PF main PWB (YC2)
Defective drive
transmission sys-
tem of the PF drive
motor.
Check if the rollers and gears rotate
smoothly. If not, grease the bushes and
gears. Check for broken gears and replace if
any.
Defective PF drive
motor.
Replace the PF drive motor.
Defective PF main
PWB.
Replace the PF main PWB (Refer to the ser-
vice manual for the paper feeder).
Code Contents Causes
Check procedures/
corrective measures