2GL/2FV/2FW
1-6-11
(2) Detaching and refitting the heater lamp, heat roller, fuser thermistor, thermal cutout, and press roller
<Procedure>
1. Remove the fuser unit. See page 1-6-9.
2. Remove the two screws and terminal.
3. Remove the heater lamp.
* Seat the heater lamp aligning its wattage
mark and welding mark faced with the cor-
rect direction and side.
Figure 1-6-16
Screw
Heat gear
Welding mark
Screw
Terminal
Heater lamp
Wattage
mark
Heater lamp
To Next Page
Loading...
