2GL/2FV/2FW
1-6-19
9. Remove the one screw and terminal from
the bottom frame plate.
* When securing the grounding terminal, hook
the grounding wire to the projection.
10. Remove the three screws from power
source PWB.
11. Remove four screws from the engine/high
voltage PWB.
12. Separate the engine/high voltage PWB and
power source PWB.
13. Check or replace the engine/high voltage
PWB or power source PWB and then refit all
the removed parts.
* To replace the engine/high voltage PWB,
remove the EEPROM (U2) from the old
engine/high voltage PWB and mount it to
the new engine/high voltage PWB.
Figure 1-6-26
Screws
Screw
Screw
Screw
Terminal
Power source PWB
Bottom frame plate
Engine/high
voltage PWB
Connectors
Screws
Screw
EEPROM
Socket
Terminal
Screw
Projection
Power source PWB
Grounding wire
To Next Page
Loading...
