2GL/2FV/2FW
1-6-23
(3) Detaching and refitting the drive unit
<Procedure>
1. Remove the right cover. See page 1-6-2.
2. Remove the three connectors.
3. Remove the two screws and then remove
the two grounding plates.
4. Remove the two stoppers and then remove
the two clutches.
Figure 1-6-31
5. Remove the one screw and then remove the
CF guide.
6. Remove the three screws and then remove
the drive unit.
Figure 1-6-32
Screw
Clutch
Clutch
(black)
Stopper
Stopper
Grounding plate
Grounding plate
Screw
Connectors
Screw
Screw
Screw
Drive unit
Screw
CF guide
To Next Page
Loading...
