2GL/2FV/2FW
1-7-3
3. Turn printer power on.
4. Confirm that LED indication status () is
displayed.
5. At the DOS prompt, enter command.
c:\echo!R!UPGR”SYS”;EXIT;>prn
6. Confirm that LED indication status () is
displayed.
7. Confirm that LED indication status () is
displayed. At the DOS prompt, enter com-
mand so that the system firmware (example:
S2FV_1000001021.cmp) is copied to the
printer.
c:\copy\2FV_1000001021.cmp prn
8. LED indication status ()() are displayed
during downloading. When LED indication
status () is displayed to indicate down-
loading is finished, turn printer power off,
then on.
* If downloading fails, the printer indicates an
error display using the LED indicators. See
table below, LED indication status ().
9. Confirm that LED indication status () is
displayed after warm-up.
10. Print a status page. (See page 1-4-3)
11. Check that the status page shows the
updated firmware version.
Table 1-7-1
Waiting for
parallel data
Receiving data
Deleting and
writing data
Supervisor mode
Ready
Downloading
complete
Downloading
failed
Off
Off
Lit
Lit
LED Indicator explanatory notes
READY indicator
ATTENTION indicator
To Next Page
Loading...
