2GL/2FV/2FW
1-7-5
4. Turn power switch on.
5. The printers starts and finishes downloading
automatically. LED indication status ()()
are displayed during downloading. When
LED indication status () is displayed to
indicate downloading is finished.
* If downloading fails, the printer indicates an
error display using the LED indicators. See
table below, LED indication status ().
Table 1-7-2
6. Turn power off.
7. Remove the memory card and then refit the
right side cover.
8. Turn power on again. Check the printer gets
ready.
9. Print a status page. (See page 1-4-3)
10. Check that the status page shows the
updated firmware version.
Receiving data
Supervisor mode
Ready
Downloading
complete
Off
Off
Lit
Lit
LED Indicator explanatory notes
READY indicator
ATTENTION indicator
Deleting and
writing data
Downloading
failed
To Next Page
Loading...
