Kyocera FS-C2626MFP - Page 31

2-4
Registering Destinations > Registering Destinations in the Address Book
7
Select transmission settings
The transmission start speed, ECM communication, and encrypted transmission can be set.
1 Press [Detail Settings].
2 Configure the transmission start speed.
3 Turn on ECM communication.
ECM (error correction mode) is a function to automatically resend an image that has not been
correctly sent or received due to the effects of noise on the telephone line during transmission.
4 Turn on encrypted transmission.
To use encrypted communication for transmission, turn on encrypted transmission.
For the procedure for turning on encrypted transmission, refer to Encryption on page 6-36.
NOTE
Normally the default setting should be used.
FAX
10:10Ready to send.
Cancel
Sub Address
Pause Space Backspace
Detail Settings
OK
0123456789
GB0075_03
TX Start Speed
10:10Ready to send.
ECM
Cancel
1/1
33600bps
On
Encrypted Transmission
Off
FAX - Detail Settings
OK
Detail Settings - TX Start Speed
10:10Ready to send.
14400bps
33600bps
9600bps
Cancel
1/1
OK
2
1
GB0168_01
GB0172_01
TX Start Speed
10:10Ready to send.
ECM
Cancel
1/1
33600bps
On
Encrypted Transmission
Off
FAX - Detail Settings
OK
Detail Settings - ECM
10:10Ready to send.
On
Off
Cancel
1/1
OK
2
1
GB0168_01
GB0173_01
Encryption
10:10
Cancel
1/1
Off
Detail Settings - Encrypted Transmission
OK
Ready to send.
TX Start Speed
10:10Ready to send.
ECM
Cancel
1/1
33600bps
On
Encrypted Transmission
Off
FAX - Detail Settings
OK
2
1
GB0168_01
GB0174_00