The following example uses
sales820ptr
as the print server name and
sales820q
as the print queue name:
# lpadmin -p sales820q -m netstandard -o protocol=bsd -o dest=sales820ptr:lp1 -v /dev/null
3. Enable the printer queue.
#/usr/sbin/accept sales820q
#/usr/bin/enable sales820q
Printing, Canceling a Print Job, and Checking Queue Status
The commands for these functions are explained in the Printing, Canceling a Job, and Checking Status
section.
Controlling the Banner Page
banner page is printed by default. If a banner page is not desired, add "-o nobanner" when printing, e.g.:
# lp -d sales820q -o nobanner
file name
or
# lpadmin -p sales820q -o nobanner
The banner page default may also be changed by editing the interface file in
/etc/lp/interfaces
. Open the interface file
using an editor such as
vi
and change "nobanner=no" to "nobanner=yes".
# vi /etc/lp/interfaces/sales820q
Solaris 2.3x - 2.5x Setup
This section explains how to setup printing in Solaris 2.5x and earlier versions. The instructions below are for Solaris 2.4.
The commands and paths listed in the following procedures may vary slightly depending upon the OS version.
Remote Printer cannot be configured in OpenWindows using the Admintool. It should be setup using the following
procedure:
Configuring the Print System
1. Login as root.
# login root
2. Stop the print scheduler.
# /usr/sbin/lpshut
3. Add the print server.
The following example uses
sales820ptr
as the print server name:
# /usr/sbin/lpsystem -R0 -t bsd sales820ptr
4. Create the print queue.
The following example uses
sales820q
as the print queue name:
#/usr/sbin/lpadmin -p sales820q -s sales820ptr!lp1
2/8 ページUnix Printing
2006/05/26file://F:\USERMAN\EXPORT\Option\IB-23\P6以降用完了分\ｈｔｍｌ\English\unix.htm
To Next Page
Loading...
