The violet colored text in Figure 1 shows user input. The following directions correspond with the red numbers in Figure 1.
1. Change to the directory that you would like the configuration file to be copied to.
2. Open an ftp session with the source IB-23.
3. Enter
admin
as the User.
4. Enter the Admin password. If the user name and password are verified, the ftp session should respond with "User
Logged in."
5. Enter
get config
to read all settings to a file called
config
.
6. Enter
quit
or
bye
to exit the ftp session.
7. A directory listing shows that there is now a file in the current directory called
config
.
;;; General ;;;
;Admin Password = "*****"
Firmware Update Utility = ENABLE
LAN Interface = AUTO
;;; TCP/IP ;;;
TCP/IP Protocol = ENABLE
Host Name = "KM123456"
IP Address = 10.10.10.220
Subnet Mask = 255.255.255.0
Default Gateway = 10.10.10.1
DHCP = ENABLE
BOOTP = ENABLE
RARP = ENABLE
ARP/PING = ENABLE
Bonjour = ENABLE
Bonjour Name = "KM123456"
FTP Status Check = DISABLE
;;; DNS ;;;
DNS Server (Primary) = 207.214.73.16
DNS Server (Secondary) = 207.214.140.10
Domain Name = ""
;;; WINS ;;;
WINS Server (Primary) = 192.168.1.1
WINS Server (Secondary) = 0.0.0.0
Scope ID = ""
;;; IP Filter ;;;
IPFILTER1 Start Address = 10.10.10.40
IPFILTER1 End Address = 10.10.10.55
IPFILTER1 Protocol = "LPD, FTP, IPP, HTTP, SNMP, RAW Port"
IPFILTER2 Start Address = 10.10.10.55
IPFILTER2 End Address = 10.10.10.73
IPFILTER2 Protocol = "LPD"
IPFILTER3 Start Address = 0.0.0.0
IPFILTER3 End Address = 0.0.0.0
IPFILTER3 Protocol = ""
2/5 ページConfiguration Using ftp
2006/05/26file://F:\USERMAN\EXPORT\Option\IB-23\P6以降用完了分\ｈｔｍｌ\English\ftp.htm
To Next Page
Loading...
