NETWORK SCANNER SETUP GUIDE 3
2Setup
Date and Time Settings
Setting the Time Zone
You can also make this setting using the COMMAND CENTER. For details on
COMMAND CENTER, refer to Accessing COMMAND CENTER on page 7.
1 Access Time Zone.
2 Press S or T to select the time zone that you are in.
3 Press Enter. The message display shows Completed and returns to the Date/
Timer Set. screen.
4 Enable Summer Time if needed - refer to Summer Time Setting on page 3.
Summer Time Setting
Follow these instructions to turn the summer (daylight saving) time setting on and off.
NOTE: This setting is valid only in areas where summer time is observed.
1 Press S or T to select Summer Time.
2 Press Enter.
3 Press S or T to select either On or Off.
4 Press Enter. The message display shows Completed and returns to the Date/
Timer Set. screen.
5 Enter the Date and Time - refer to Setting the Current Date and Time on page
4.
System Menu/
Counter
S or T
Date/Timer Set
Enter
S or T
Time Zone
Enter
Get other manuals https://www.bkmanuals.com
To Next Page
Loading...
