Kyocera KM-3060 - Page 53

FAX Operation (Basic)
OPERATION GUIDE 3-21
3
13
Press [T] of Mode and select Simple or Full.
14
Press [Destination Condition].
15
Specify the destination conditions and press [OK].
16
Press [OK].
17
Press [OK].
18
Check if the destination has been set correctly, and press [Register].The
destination is added to the Address Book.
Transmission
mode
Description
Simple mode Transmission confirmation is not sent to the
destination machine.
Full mode Transmission confirmation is sent to the
destination machine.
Item Description
Resolution Specify the resolutions that can be received by
the destination fax machine.
If you try to send an i-FAX using a prohibited
resolution, it is automatically changed to a
permitted resolution and then sent.
• 200 × 100 dpi: Permitted (fixed)
• 200 × 200 dpi: Permitted (fixed)
• 200 × 400 dpi: Permitted or prohibited
• 400 × 400 dpi: Permitted or prohibited
• 600 × 600 dpi: Permitted or prohibited
To permit a resolution setting, press the key for
that resolution so that it is highlighted.
To prohibit a resolution, press the key again so
that it is no longer highlighted.
Compression Select a suitable file format for the destination
fax machine.
MH, MR, MMR or JBIG
Paper Size Specify the suitable document size options for
the destination fax machine.
• A4/Letter: Permitted (fixed)
• B4: Permitted or prohibited
• A3/Ledger: Permitted or prohibited
To permit a document size setting, press the key
for that size so that it is highlighted.
To prohibit a setting, press the key again so that
it is no longer highlighted.