4-12
4. Selecting the Printer Settings
Item
1 Selecting the font
Selects the font that will be used for printing. This setting
is made by entering the ID of the desired font. To select a
font that is already installed in the printer, enter “I###”
(with the desired font ID entered in place of ###). To verify
font IDs, print out a Font List by following the procedure in
“(18) Font List print out”. It is possible to select a font other
than those already installed, such as those contained in
the optional Memory Card.
Optional font IDs such as “S###”, etc., start with different
letters according to the type of the font as shown below.
S: Software font (download)
M: Memory card font
H: Hardware font
H: RAM disk font
O: Optional ROM font
2 Courier
Allows you to select between “Regular” and “Dark (bold)”.
3 Letter Gothic
Allows you to select between “Regular” and “Dark (bold)”.
4 Font List print out
Available settings
Regular
Dark
Regular
Dark
Remarks
The font can be set separately for
each interface. To select an installed
font, select “Internal”. To select a font
other than those already installed,
select “Option” and set the desired
font.
Displayed only when the “Internal” is
selected.
Displayed only when the “Internal” is
selected.
4-4 Font selection/settings
About the font selection/settings
It is possible to perform font selection/settings for the 4 items shown in the following chart.
For the most efficient use of the printer functions, select the various settings according to your printing needs.
To Next Page
Loading...
