Kyocera TASKALFA 300I - Protocol Detail

Default Setting (System Menu)
8-66
5 Press [On] or [Off] of DHCP. When selecting [On], IP Address (Stateful) appears.
6 Press [OK].
7 After changing the setting, restart the system or turn the machine OFF and then ON again.
For detailed information on restarting the system, refer to Restarting the System on page 8-63.
Protocol Detail
The table below lists the network related function settings. The network related functions are available when
TCP/IP is On.
Item Description
Default
Setting
Restarting the
System*
NetBEUI Selects whether or not to receive
documents using NetBEUI.
On Y
LPD Select whether or not to receive
documents using LPD as the network
protocol.
On Y
SMTP
(E-mail TX)
Select whether or not to send e-mail
using SMTP.
Off N
POP3
(E-mail RX)
Select whether or not to receive e-mail
using POP3.
Off N
FTP Client
(Transmission)
Select whether or not to send
documents using FTP. When selecting
[On], set the FTP Port Number. Use
the FTP default port 21.
On
Port:21
Y
FTP Server
(Reception)
Select whether or not to receive
documents using FTP.
On Y
SMB Client
(Transmission)
Select whether or not to send
documents using SMB. When
selecting [On], set the SMB default
Port Number. Use the SMB default port
139. For Windows Vista, use 445.
On
Port:139
N
i-FAX Select whether or not to use i-FAX. On N
LDAP Select whether or not to use LDAP. Off N
SNMP Select whether or not to communicate
using SNMP.
On Y
SNMPv3 Select whether or not to communicate
using SNMPv3.
Off Y
HTTP Select whether or not to communicate
using HTTP.
On Y