Kyocera TASKalfa 4012i - Page 425

8-69
Setup and Registration (System Menu) > System Menu
Low Power Timer Set amount of time before entering the Low Power mode.
Value
For Europe: 1 to 120 minutes (1 minute increments)
Except for Europe: 1 to 240 minutes (1 minute increments)
Low Power Mode (page 2-39)
Panel Reset Timer If you select [ On ] for Auto Panel Reset, set the amount of time to wait before Auto Panel
Reset.
Value: 5 to 495 seconds (in 5 second increments)
NOTE
This function is displayed when [Auto Panel Reset] is set to [On].
Sleep Timer Set amount of time before entering Sleep.
Value
For Europe
1 to 120 minutes (1 minute increments)
Except for Europe
1 to 240 minutes (1 minute increments)
Interrupt Clear Timer Set the period after which the machine reverts to Normal mode when it has been set
to Interrupt Copy mode and then left unused.
Value: 5 to 495 seconds (in 5 second increments)
Error Job Skip Set whether a job for which a "Add paper in cassette #" or "Add paper in Multipurpose
tray" error occurred when the job was started is automatically skipped after a set period
of time elapses.
Value: Off, On
NOTE
• When a job is skipped, it is moved to the end of the job queue.
• If [On] is selected, set the time until the job is skipped. The setting range is 5 to 90
(5 second increments).
Error Clear Timer If you select [On] for Auto Error Clear, set the amount of time to wait before
automatically clearing errors.
Value: 5 to 495 seconds (in 5 second increments)
NOTE
This function is displayed when [Auto Error Clear] is set to [On].
Unusable Time
*1
Set a time period during which the machine will not print received faxes.
FAX Operation Guide.
Sleep Rules (models for
Europe)
Select whether to use the Sleep mode for the following functions individually:
• ID Card Reader
*2
• Application
Value: Off, On
NOTE
• If the sleep condition is not turned off, the machine will not wake from sleep mode
even if it receives a print job from a computer connected by USB cable. Also, the
ID card cannot be recognized.
• This function will not be displayed when the optional Network Interface Kit or Fiery
controller is installed.
Item Description