Copying Functions
4-23
4
Form Overlay
Copy the original images onto the form. Once you scan
and register the form, the form is overlaid onto the
original. You can also use a form that is already
registered in the machine's memory.
NOTE: The optional Expansion Memory is required.
To register a form in advance, refer to Form for Form
Overlay on page 7-20 for details.
Follow the steps shown below for form overlay.
1 Press the Copy key.
2 Press [Layout/Edit] and then [Form Overlay].
3 Press [Scan New Form] to use the first page of
originals as a form.
NOTE: You can select the form density setting through
4 levels from 10%, 20%, 30% or 100%. Press the [+] or
[-] buttons in Density.
To use the forms already registered, press [Select
Stored Form]. Press [Select Form] to display the
document boxes that store documents which can
be used as a form. Select the desired form from the
list and press [OK].
NOTE: To return to a higher level folder, press [Up].
4 Press [OK].
5 Place the originals.
Place the original for the form on top of the other
originals. When using the optional document
processor, the first page of the originals should be
placed on the top.
6 Press the Start key to start copying.
To Next Page
Loading...
