Document Box
7-20
Form for Form Overlay
Storing a Form
You can store forms to be used for the form overlay in the Form for Form Overlay box. One page can be
registered in one form.
Use the procedure below to store a form.
1 Press the Document Box key.
2 Place the original in the document processor or on
the platen.
3 Press [Job Box].
4 Select [Form for Form Overlay] and press [Open].
5 Press [Store File].
6 If necessary, select the image quality of original,
scanning density, etc. before the original is
scanned.
7 Press the Start key. The original is scanned and
stored in the Form for Form Overlay box.
NOTE: For information on using image overlays with a
stored form, see Form Overlay on page 4-23 and Form
Overlay from Custom Boxes (Form Overlay) on page
7-9.
To Next Page
Loading...
