Kyocera TASKalfa 5550ci - Page 141

2LK/2LN/2LM/2LC-2
1-3-47
U053 Setting: [Motor1 Half]
1. Select the item to be adjusted.
Setting: [Motor2 Half]
1. Select the item to be adjusted.
*: 45 ppm/55 ppm model only.
Setting: [Motor3 Half]
1. Select the item to be adjusted.
*: 45 ppm/55 ppm model only.
Item No. Description
Display Description
Setting
range
Initial
setting
Drum(K) Drum motor K (DRM-K) in half speed -5000 to 5000 0
Display Description
Setting
range
Initial
setting
Dev(K) Developer motor K (DEVM-K) in half
speed
-5000 to 5000 0
Dev(CMY) Developer motor MCY (DEVM-MCY) in
half speed
-5000 to 5000 0
Trans Belt Transfer motor (TRM) in half speed -5000 to 5000 0
Regist* Registration motor (RM) in half speed -5000 to 5000 0
Belt Clean Transfer cleaning motor (TRCM) in half
speed
-5000 to 5000 0
Display Description
Setting
range
Initial setting
30ppm 35ppm 45ppm 55ppm
SB Eject motor (EM) in half
speed
-5000 to 5000 -102 -87 -67 -60
Fixing Fuser motor (FUM) in half
speed
-5000 to 5000 0 0 0 0
Bridge1 Bridge conveying motor 1
(BRCM1) in half speed
-5000 to 5000 -107 -92 -71 -63
Bridge2 Bridge conveying motor 2
(BRCM2) in half speed
-5000 to 5000 -107 -92 -71 -63
Feed Paper feed motor (PFM)
in half speed
-5000 to 5000 0 0 0 0
Job Sepa-
rator
JS eject motor (JSEM) in
half speed
-5000 to 5000 0 0 0 0
Mid Roller* Middle motor (MM) in half
speed
-5000 to 5000 - - 0 0
DU1* Duplex motor 1 (DUM1)
in half speed
-5000 to 5000 - - -100 -80
DU2* Duplex motor 2 (DUM2)
in half speed
-5000 to 5000 - - -100 -80