2LK/2LN/2LM/2LC-2
1-2-46
27. Fit the tray retainer to the machine
using the M4 x 8 screw.
*: The procedure described above is not
required if an optional right job separator
has been installed.
Figure 1-2-60
28. Refit the right upper cover.
29. Refit the ISU right cover.
30. Close the paper conveying unit.
31. Fit the tray cover to the tray stay using
four M4 x 8 screws.
Figure 1-2-61
Tray retainer
Tray retainer
M4 x 8 screw
M4 x 8 screw
M4 x 8 screws
Tray cover
Tray stay
M4 x 8 screws
To Next Page
Loading...
