Kyocera TASKalfa 5550ci - Page 77

2LK/2LN/2LM/2LC-2
1-2-53
Fitting the KMAS interface PWB
2. Remove seven screws and then
remove the rear upper cover.
Figure 1-2-67
3. Attach one spacer A and three spacers
B to the side of the controller box.
Figure 1-2-68
Rear upper cover
Screws
Screws
Screw
Screws
Spacer B
Spacer B
Spacer A
Controller box
Spacer B