3-19
Sending Faxes > FAX Direct Transmission
Cancelling Delayed Transmissions (Queued)
1
Display the screen.
[Status/Job Cancel] key > [Scheduled Job]
2
Canceling a job.
Select the job you want to cancel and select [Cancel] > [Yes].
The selected job is deleted.
Immediate transmission
1
Display the screen.
[Status/Job Cancel] key > [Scheduled Job]
2
Immediate transmission.
Select the job you want to send by immediate transmission, and select [
Menu
] > [
Start Now
] >
[
Yes
].
The transmission will start.
FAX Direct Transmission
The destination is dialed and communication starts before the original is scanned, allowing you to verify that each page
of the fax has been properly sent.
Cancelling Direct Transmission
During direct transmission, to cancel communication during transmission, select the [Stop] key on the operation panel or
[Cancel] on the touch panel. The originals that have been scanned are ejected, and the screen returns to the send
default screen. When originals remain in the document processor, take them out.
Setting for Direct transmission Description
On Starts direct transmission.
Dials the receiving system, and after the communication has started, originals are
scanned.
Off Starts memory transmission.
After originals are scanned into memory, the communication starts.
In direct transmission, you can designate only 1 destination for 1 transmission.
In the basic screen for sending, select [Direct]. This selects the direct transmission method and the keys on the touch
panel are highlighted.
In some cases, transmission may take place even if the [Stop] key or [Cancel] is selected.
To Next Page
Loading...
