―17―
７−１ DataHold
This is a function used to freeze the measured value on the
display.
①Press the data hold switch. The reading becomes frozen and the
"H" symbol is shown on the display, indicating the instrument in the
data hold mode.
②To exit the data hold mode, press the data hold switch again to
release it.
NOTE
● When the function selector switch is turned while the instrument is
in the data hold mode, the data hold function remains activated.
To make measurement in this case, release the data hold switch
by pressing it and exit the data hold mode.
● The data hold function is disabled in the peak measurement mode
on the AC current range.
● When the sleep function is activated, the data hold mode turns to
the normal mode.
７−２ SleepFunction
This is a function to prevent the instrument from being left powered
on in order to conserve battery life.
①The instrument automatically enters the sleep (powered-down)
mode about 10 minutes after the last switch operation.
②To exit the sleep mode, press the data hold, reset or mode switch
or turn the function selector switch back to "OFF", then to any other
position.
［How to Exit the Sleep Mode ］
①Turn the function selector switch from "OFF" to another position with
the data hold switch pressed. Then, "P.OFF" is shown on the
display. This disables the sleep function and enables continuous
use of the instrument.
７．NotesonFunctions
To Next Page
Loading...
Need help?
General
