L3 comminications ProTec User Manual (English)

Need help?

Do you have a question about the L3 comminications ProTec and is the answer not in the manual?

L3 comminications ProTec Specifications

General

Brand	L3 comminications
Model	ProTec
Category	Marine Radio
Language	English

Summary

SECTION 1: ProTec AIS Introduction

1.1. General

1.1.1. System Overview

1.2. Technical Specifications

Outlines the technical specifications of the AIS transponder, including standards and transmitter/receiver capabilities.

1.3. AIS Description

1.3.2. Integral Minimum Keyboard Display (MKD)

1.3.3. Integral GPS

1.3.4. Data Interface

1.3.5. Equipment List

1.3.6. Operational Modes

Explains the different operational modes of the ProTec AIS: Autonomous, Assigned, and Polled.

1.3.7. DSC Functionality

1.3.8. AIS Broadcast Parameters

Details the information broadcast by the AIS unit and the broadcast intervals.

1.4. Interface Description

1.4.1. Pilot Systems Input Data and Formats

1.4.2. Pilot Systems Output Data and Formats

1.4.7. Sensor Input Data and Formats

SECTION 2: ProTec Operation

2.1. Operation

Details on the normal operation of the L-3 ProTec AIS, focusing on user interaction.

2.1.1. Minimum Keyboard Display

2.1.2. Keypad Description

2.1.3. Data Display Screens

2.1.4. Data Entry Screens

Describes the data entry screens for vessel/voyage data and system configuration.

2.1.4.1 Vessel Data Setup

Guides the user through entering essential vessel and voyage information required for AIS installation.

2.1.4.2 Channel Management

Explains how to configure and manage up to eight different AIS channel configurations.

2.1.4.3 Antenna Position

2.1.4.5 Password Entry

2.1.4.6 Change Password

SECTION 3: ProTec Installation

3.1. Installation

Provides an overview of the AIS transponder installation process and system layout.

3.1.1. Transponder

Details the mounting and initial connections for the transponder unit.

3.1.2. Connecting the IEC Data Interface Cable

Explains how to connect the IEC data interface cable for sensor and data input.

3.1.2.1 Data Channels

3.1.2.2 Data Cable

3.1.2.3 Terminal Block

3.1.3. Installing the VHF Antenna

Provides guidelines and steps for the correct installation of the VHF antenna.

3.1.4. Installing the GPS Antenna

Details the crucial steps and considerations for installing the GPS antenna for synchronization.

3.1.5. PowerUp and Configuration

Guides through the final setup and configuration steps after installation.

L3 comminications ProTec User Manual

Table of Contents