L3 comminications ProTec - System Alert Screen; Alarm Status; Figure 2-12. Password Change Screen; Figure 2-13. System Alert Screen

Marine Systems
Aviation Recorders
Rev. 02 Page 2--17
July 29/03
Automatic Identification System
(4) Enter the new password in both fields, and press the ENT key. This will save
the new password.
(5) Press the ESC key to go back to the System Configuration screen.
Sy
Pa
Ve
ss
ri
Put
stem
wd
fy
:
:
New
Pas
Pwd
s
i
wor d
nBo
Cha
th F
nge
ields
Figure 2--12. Password Change Screen
2.1.4.7 System Alert Screen
This screen will appear when a system alert is received. Press the ENT key to ac-
knowledge the alert.
***
***
No v
***
Sys t
Al ar
al i d
Pr es
em A
m0
COG
sEN
l
3
T
er t
0Ac
info
to
Page
tive
rmat
ACK
***
***
ion
***
Figure 2--13. System Alert Screen
2.1.4.8 Alarm Status
The ProTec AIS unit does not support a “General Failure” alarm since all detected
failures are reported with an explicit discrete alarm message.
To review Safety Text Messages that have been received, perform the
following:
(1) Press the FNC key.
(2) Press the Setup key. The System Configuration screen will appear.