Sash Stop Kit – Field Installation
(P/N 9410300)
The sash stop kit restricts how far a vertical-rising sash may be opened. This
small plastic device may be easily field installed on the fixture corner post of any
fume hood.
Upper Bypass for Premier Field Installation
The upper bypass prepares the Premier for use with variable air volume (VAV)
systems and allows the hood to use less (CFM) as detailed in Chapter 2. The part
numbers are listed below:
4' Premier Upper Bypass, P/N 9409214
5' Premier Upper Bypass, P/N 9409215
6' Premier Upper Bypass, P/N 9409216
8' Premier Upper Bypass, P/N 9409218
Installing an Electrical Duplex Outlet
Your Protector Fume Hood can be ordered with duplex outlets, however, if you
ordered a model without an electrical duplex outlet you can have one installed in
the field by a qualified electrician. Contact Labconco Customer Service for
ordering information. (Not acceptable on explosion-proof hoods).
Votre Protège-capot de fumées peut être commandé avec prises doubles,
cependant, si vous avez commandé un modèle sans prise de courant duplex, vous
pouvez en faire installer sur le terrain par un électricien qualifié. Contactez le
service clientèle Labconco pour commander. (Non acceptable sur antidéflagrants
hottes).
8' Dual Exhaust Adapters – Field Installation
The Type 304 stainless steel single exhaust adapter
allows 8' Protector Hoods to be exhausted from two
fume hood exhaust collars spaced 48" apart to a
single 12" (12.81 ID) exhaust, centered on the hood.
The single centered exhaust outlet is located 9.3"
from the rear of the hood for all 8' Protector Hoods.
For other special sizes, consult Labconco. The performance specifications for the
8' Dual Exhaust Adapters are listed below.
To Next Page
Loading...
