Chapter 4: Using Your Washer
Product Service 1-800-522-7658 27
To fill the neutralizing acid dispenser:
1. Twist and pull up on the cap to remove the round cover on the neutralizing
solution port.
2. Fill the cavity with LabSolutions Neutralizing Acid Rinse (Labconco P/N
4522200) 1M citric acid or 10% phosphoric acid until the level of the liquid
rises and is visible in the port.
3. Set the dial to read 4 ml.
4. Replace the cover.
Selecting an Operating Cycle
The microprocessor control on your Glassware Washer allows you to select a
factory programmed wash program, to modify the factory preset wash programs
or to customize two additional programs. The control panel is shown below.
Programming and Starting a Wash Cycle
Refer to Appendix C: Glassware Washer Specifications for complete details on
the various factory-set programs and the options available for customizing
programs. After you have decided which washer program to use, follow the
instructions below to start the washer.
Washers have the capability to wash glassware at high temperatures. Use care
when selecting high-heat programs if plasticware is being washed.
To Next Page
Loading...
Need help?
General
