Product Service 1-800-522-7658 32
C
C
H
H
A
A
P
P
T
T
E
E
R
R
5
5
M
M
A
A
I
I
N
N
T
T
A
A
I
I
N
N
I
I
N
N
G
G
Y
Y
O
O
U
U
R
R
W
W
A
A
S
S
H
H
E
E
R
R
Under normal operation, your Glassware Washer will require little routine
maintenance to keep it functioning properly.
Maintaining the Stainless Steel Interior
The interior of your Glassware Washer is type 304 stainless steel. Never use
metal scouring pads on the stainless steel interior. Metal scouring pads can
scratch or leave metal chips that will rust.
To maintain the appearance and quality of the stainless steel interior, perform the
following tasks as needed:
• Wipe the outer edges on the inside door panel to remove particles and
residue that occur during loading.
• Use a sponge sprinkled with non-abrasive stainless steel cleaner to gently
wipe the washer tank and door to remove surface discoloration caused by
exposure to halogenated compounds or steel parts. In some cases, the
finish may be slightly dulled by this action.
If your water has a high mineral content, film or spots may develop on the washer
interior. If the procedures listed above do not eliminate the film or spots, you
may run your washer through the special cycle below.
To remove film or spots from the washer interior:
1. Remove all glassware from the washer.
2. Choose the Glass Program, Steam OFF, Pure Rinse OFF, and set the drying
time to zero.
To Next Page
Loading...
Need help?
General
