Chapter 4: Using Your Washer
Product Service 1-800-522-7658 31
OVERFLOW
This displays if water is detected in the base of the washer. Water fill
valves will be closed and the washer will cancel the cycle and drain water
that is in the washer. The alarm is canceled by opening the door. See
Chapter 7: Troubleshooting – Washer leaks.
LIQ DETER
This displays only if the optional liquid detergent dispenser is installed
and the level of the detergent in the dispense container is low. The alarm
is disabled if the detergent dispense volume is set to “0.” The alarm is
canceled when detergent is added to the container.
DRAIN FAIL
This displays if water fails to completely drain during a normal drain
operation. Operation of the washer is canceled. The alarm is canceled by
opening the door.
LOW TEMP
This displays if the water doesn’t reach the set point temperature within
135 minutes. Operation of the washer continues. The alarm cancels when
the door is opened.
TEMP SENSOR
This displays if the temperature sensor is disconnected. It is canceled by
connecting an operable sensor.
To Next Page
Loading...
Need help?
General
