Davits (optional extra)
z
INSTALLING A TENDER ONTO THE DAVITS
- Fix the davit line hooks to the forward and aft of the tender.
- Close the blockers found on the davits.
- Pull the bow of the tender up to halfway using the cockpit winch.
- Repeat the operation for the stern.
- Alternatively raise bow and stern until the tender comes into contact
with the davits.
z
LAUNCHING A TENDER FROM THE DAVITS
- Ensure that the blockers on the davits are closed.
- Thread the davit rope attached to the stern of the tender around the
winch (minimum of three turns).
- Open the blocker and let the line feed out until halfway.
- Close the blocker.
- Repeat the procedure for the bow.
- Alternatively lower stern and bow until the tender comes into
contact with the water.
Environment
Do not discharge oil into the sea.
Take every precaution to prevent hydro-fuel overflow when filling the
engine tank.
When in port, only use the onboard toilets if they are equipped with
organic waste reservoirs.
The use of detergents is implicated in the destruction of marine plant
and animal life. Choose fully biodegradable cleaning products.
Do not throw plastic bags and bin bags into the sea. Use the bins
provided for this purpose at ports.
NAVIGATION
21
NAVIGATION
1
LAGOON 44O
RECOMMENDATION
We share a love for the ocean. Help us to preserve
them!
WARNING
Nobody should be aboard the tender during
maneuvers carried out with the davits. Tie up the
tender out of the way during maneuvers.
WARNING
The davits are designed to support a maximum load
of 250 kg and a tender of 3.80 meters in length at
maximum.
WARNING
When under sail remove the tender engine and store
it on board the boat.
Secure the tender according to sea conditions.
To Next Page
Loading...
