z
AFTER MAST STEPPING
- Lubricate all the turnbuckles (see recommendations in the RIGGING
chapter).
- Tension the rigging (refer to RIGGING chapter for settings).
- Reconnect the electrical cables in the junction box at the base of the
mast located in the forward cockpit locker after running the cables
through the gooseneck located at the front of the mast (see
ELECTRICITY chapter).
- Carefully check the tightness of the turnbuckle cotter pins, and
protect with adhesive tape.
- Replace the boom and re-lead all the lines.
z
DISMASTING
Proceed by carrying out the operations recommended for stepping the
mast in reverse order, taking care to mark the line locations with
stickers.
LAUNCHING
33
LAUNCHING
3
LAGOON 44O
RECOMMENDATION
Re-adjust the mast after a few miles.
RECOMMENDATION
Before all dismasting operation, remember to
disconnect the electric cables.
Pull gently while guiding the cables.
To Next Page
Loading...
