Water tanks
z
FILLING
In order to prevent any handling mistakes, never fill the water and fuel
tanks at the same time.
During filling, avoid handling contaminants near the fillers.
Open and close the filler caps with the suitable key.
Check the filler cap seals for condition during filling.
The tanks are fitted with overflow outlets and vents.
Never insert the water filling hose deep down into the system in order
to prevent any over-pressure in the systems.
z
MAINTENANCE
Inspection points are provided on tanks and from which it is possible
to clean the inside.
NB: The capacity of the fresh water tank or tanks indicated on the
SPECIFICATIONS page may not be completely useable depending on
the trim and load of the boat.
. Fresh water system
The water pump is switched on at the electrical panel.
The three tanks are linked through gravity. The overall level can be
read on mark n°1 on the electrical panel gauge.
Gas system
Refer to the SAFETY chapter.
Refer to the "FRESH WATER AND GAS" diagram.
When changing the gas bottle, refit the cap in place on the regulator
threaded section (to avoid corrosion).
PLUMBING
71
PLUMBING
7
LAGOON 44O
RECOMMENDATION
- Check the quality of the water when filling. Check
whether or not it is drinking water.
- The tanks can be sterilized using a Clonazione
tablet (available from chemists).
- In the case of long periods of inactivity purify tanks
and piping using the appropriate treatment.
RECOMMENDATION
Shut off the gas safety valve and the regulator valve
when the stove is not in use.
RECOMMENDATION
- Never operate the water system equipment when
the valves are closed or the tank is empty (the
electrical equipment may be damaged).
- Check the water filter for condition (refer to
manufacturer's instructions).
To Next Page
Loading...
