lancer 810LX - Instructions to Respect in Case of Changing the Product Formula; Change of the Tanks

CHAPTER 2
BEFORE YOU START
NU_810-815_LX_ANG_1306
18
4.3 INSTRUCTIONS TO RESPECT IN CASE OF CHANGING THE PRODUCT
FORMULA
Before changing to a different type or brand of cleaning chemical (acid or detergent) it is necessary
to rinse the plumbing circuitry of the machine. Install the new chemical(s) per the installation
instructions and then prime the detergent and acid pumps. Then a wash cycle can be
programmed and run which uses several rinses with water only. This will prevent any cross
contamination of chemicals.
After the new cleaning chemical have been installed, it will be necessary to adjust the chemical
dosing times in all applicable steps of the wash cycle in order to match the formulation of the new
cleaning chemicals.
Please contact GETINGE LANCER for advice or assistance.
4.4 CHANGE OF THE TANKS
Before launching the cycle, check product tank levels and change those with low levels so as to
avoid bad washing because of a lack of additive.
WHEN TO CHANGE THE CHEMICAL CONTAINERS
This message is displayed when the chemical bottles are almost empty.
WARNI NG
L A C K O F C H E M I C .
It is necessary to fill or change the detergent or acid containers to continue the cycle.
HOW TO CHANGE THE CHEMICAL CONTAINERS ?
Press
button to switch off the washer.
Use the necessary protection for the chemical to be changed (gloves, mask, safety glasses…) .
Locate the container(s) that need to be changed.
Unscrew the cap(s) from the empty chemical bottle(s) and take out the chemical suction tube(s).
Unscrew the cap(s) from the full chemical bottle(s) and insert the chemical suction tube(s). Tighten
the cap(s) to secure the chemical suction tube in place.
Press
button to switch the washer on.
Dispose of used chemical bottles or caps according to local and company regulations. Please
consult the Material Safety Data Sheet for specific information regarding the chemicals used in the
washer.