lancer 810LX - 3.5 FAULT N°5 NO WATER.; 3.6 FAULT N°6 DOOR FAULT; 3.7 FAULT N°7 LEVEL FAULT.

CHAPTER 6
PROBLEMS
NU_810-815_LX_ANG_1306
67
3.5 FAULT N°5 NO WATER.
F A U L T n ° 0 5
N O WATER
No Water Definition :
The washer did not reach the required water level by the end of the normal filling time
defined in the Common Times menu.
Corrective Action :
Check that the water inlet valves are open, that the water inlet pipes are in good condition
and that the water inlet filters are clean.
This message may be displayed during filling for
PREWASH 1, PREWASH 2, PREWASH 3, WASH ,
RUNNING WATER RINSE
1, ACID RINSE, RUNNING WATER RINSE 2, COLD DEMI. WATER RINSES and
HOT DEMI. WATER RINSE.
3.6 FAULT N°6 DOOR FAULT
F A U L T N ° 0 6
O P E N E D D O O R
Door Fault Definition :
This message is displayed when the door is opened during the cycle. The cycle is
stopped.
Corrective Action :
Shut the door and start the cycle again.
3.7 FAULT N°7 LEVEL FAULT.
F A U L T N ° : 0 7
F I X T O L E V E L
Fix to Level Definition :
After achieving the proper water level during the Filling Time, the water level has dropped
causing the pressurestat to open times to indicate fluctuation of the water level in the
machine.
Corrective Action :
Check if you have a leak or if the emptying tube is out of location.