CHAPTER 3
WASHING CYCLE LAUNCHING
NU_810-815_LX_ANG_1306
50
9. USER CYCLE PROGRAMMING TABLE
The programs 11 to 14, 21 to 24, 31 to 34, 41 to 44 are free and can be programmed by yourself.
Water consumption estimated per phase (depends on the baskets/racks used): 12 liters.
Output from acid and detergent pumps (depends on the chemicals used): 280 ml/min.
SEQUENCES POSSIBILITIES
PROG. PROG. PROG. PROG.
PREWASH TIME 1 0 to 30 mn
FILLING CWM / PW
PREWASH 1 TEMPERATURE 0 to 85 °C
PREWASH 1 DETERGENT 0 to 360 s
OPTION : PREWASH 1 NEUTRALIZATION 0 to 360 s
PREWASH TIME 2 0 to 30 mn
FILLING CWM / PW
PREWASH 2 TEMPERATURE 0 to 85 °C
PREWASH 2 DETERGENT 0 to 360 s
OPTION : PREWASH 2 NEUTRALIZATION 0 to 360 s
PREWASH TIME 3 0 to 30 mn
FILLING CWM / PW
PREWASH 3 TEMPERATURE 0 to 85 °C
PREWASH 3 DETERGENT 0 to 360 s
OPTION : PREWASH 3 NEUTRALIZATION 0 to 360 s
WASH TIME 0 to 30 mn
FILLING CWM / PW
WASH TEMPERATURE 0 to 85 °C
WASH DETERGENT 0 to 360 s
OPTION : WASH NEUTRALIZATION 0 to 360 s
RUNNING WATER RINSE 1 0 to 9
FILLING CWM / PW
ACID RINSE TIME 0 to 30 mn
FILLING CWM / PW
ACID RINSE TEMPERATURE 0 to 85 °C
NEUTRALIZING ACID 0 to 360s
OPTION : ACID RINSE NEUTRALIZATION 0 to 360 s
RUNNING WATER RINSE 2 0 to 9
FILLING CWM / PW
COLD DEMI. TIME 1 0 to 30 mn
FILLING PW
HOT DEMI. TIME 0 to 30 mn
FILLING PW
HOT DEMI. TEMPERATURE 0 to 85 °C
DRYING TIME (*)
0 to 90 mn
DRYING (*)
0 or 110°C
COOLING 0 to 30 mn
(*) : Applicable only on models 815 LX.
It is not recommend to set wash programs at maximum values for
time and temperature as this will result in reduced equipment life
and increased maintenance frequency of equipment.
If you wish to create a custom wash program, please refer to the
factory default programs for examples of typical times and
temperatures.
You may also contact your GETINGE LANCER representative for
advice on creating wash programs.
To Next Page
Loading...
