TCP/IP Configuration
4 - 6
4.1.3 Using a DHCP, BOOTP, or RARP Reply
At boot time a host-based DHCP, BOOTP, or RARP server can respond to an MPS request
for an available IP address. For information about conÞguring the DHCP, BOOTP, or
RARP server, see your host documentation.
4.1.4 Using the Command Line Interface
1. Connect to the serial port (Port 1) using a terminal emulation program. The serial
settings should be 9600 baud, 8 bits, 1 stop bit, no parity.
2. Become the privileged user and enter the new IP address.
Local> SET PRIVILEGED
Password> system (not echoed)
Local>> DEFINE SERVER IPADDRESS 192.0.1.201
To Next Page
Loading...
