LAT Configuration
6 - 3
6.1.1 LAT Host Troubleshooting
By default, the LAT error message codes on the host are not translated into text error
messages. If a LAT job fails and appears in the queue with an eight-digit hex result code,
the code can be translated by issuing the following commands:
$ SHOW QUEUE/FULL/ALL queue_name
(note the error code nnnnnnnn)
$ SET MESSAGE SYS$MESSAGE:NETWRKMSG.EXE
$ EXIT %Xnnnnnnnn
Table 6-1: Troubleshooting LAT ConÞgurations Using a Port
Area to check Explanation
The speciÞed node name matches the
ServerÕs node name
Use the Show Server command.
The speciÞed port name matches the portÕs
name
Use the List Port 1 command.
To Next Page
Loading...
Need help?
General
