Lantronix MPS100 Installation Guide

Updating Software
D - 6
D.4.2 NetWare
The MPS.SYS Þle should be placed in the login directory on the NetWare Þle server. The
Server cannot actually log into the Þle server (since it knows no username/password); it
can only access Þles in the login directory itself. On the Server, specify the Þle server
name, Þlename, and path.
D.4.3 TCP/IP
Before the Server downloads the new software, it will send DHCP, BOOTP, and/or
RARP queries (BOOTP and RARP queries are enabled by default). Next, the Server will
attempt to download the MPS.SYS Þle using TFTP (Trivial File Transfer Protocol).
If a host provides DHCP, BOOTP, or RARP support, it can be used to set the Server's IP
address (all) and loadhost information (BOOTP and RARP only). Add the Server's name,
Local> SET PRIVILEGED
Password> SYSTEM (not echoed)
Local>> DEFINE SERVER NETWARE LOADHOST fileserver
Local>> DEFINE SERVER SOFTWARE SYS:\LOGIN\ MPS.SYS
Local>> INITIALIZE RELOAD

Lantronix MPS100 Specifications

General

Brand	Lantronix
Model	MPS100
Category	Print Server
Language	English