Lantronix MPS100 Installation Guide

Updating Software
D - 7
IP address, hardware address, and download path and Þlename to the appropriate host
Þle (usually /etc/bootptab).
Some BOOTP and TFTP implementations require a speciÞc directory for the MPS.SYS
Þle; in this case the path should not be speciÞed in the bootptab Þle and the Þle must be
placed in that directory. See your hostÕs documentation for instructions on how to
conÞgure the MPS.SYS Þle in the directory.
If BOOTP cannot be used to conÞgure the Server's IP parameters, conÞgure them by
hand using the following commands listed below.
NOTE: For instructions on how to log into the Server and enter these commands,
refer to Chapter 6, TCP/IP Configuration.
Local> SET PRIVILEGED
Password> SYSTEM (not echoed)
Local>> DEFINE SERVER IPADDRESS nnn.nnn.nnn.nnn
Local>> DEFINE SERVER SOFTWARE “/tftpboot/ MPS.SYS”
Local>> DEFINE SERVER LOADHOST nnn.nnn.nnn.nnn
Local>> LIST SERVER BOOT
Local>> INITIALIZE RELOAD

Lantronix MPS100 Specifications

General

Brand	Lantronix
Model	MPS100
Category	Print Server
Language	English