Lanzar VBP251 - Vibe Pro Series Amplifiers; VBP231 1000 Watts 2 Channel High Power Mosfet ampLIFIER; VBP241 1600 Watts 2 Channel High Power Mosfet Amplifier; VBP251 2200 WATTS 2 Channel High Power mosfet Amplifier

32
VBP251 2200 Watts 2 Channel High Power MOSFET Amplifier
Electronic Crossover Network •
Line Outs for L/R Channels •
Bass Boost Circuit•
Tri-Mode Capable •
Gold RCA Inputs •
Bridgeable at 4 Ohms •
2 Ohm Stereo Stable•
Advanced Protection Circuitry •
Stify Regulated PWM-Type Power Supplies •
Variable Input Level Controls for Each •
Pair of Channels
Frequency Response: 15Hz-35kHz •
Variable Low Pass Filter Control: 40Hz~350Hz•
Variable High pass Filter Control: 40Hz~3kHz•
Variable Bass Boost Control: 0dB-6dB-12dB (SW)•
High-Efciency, Heavy Aluminum Heatsink •
Power Protection LED Indicators •
Soft Turn On/Off•
S/N Ratio: >95dB •
2 x 550 Watts RMS at 4 Ohms •
2 x 1100 Watts MAX at 4 Ohms •
2 x 990 Watts RMS at 2 Ohms•
1 x 2200 Watts MAX at 4 Ohms MONO •
Fuse: 30A x 2•
9.33’’(W) x 2.56’’(H) x 13.79’’(L)•
VBP261 3500 Watts 2 Channel High Power MOSFET Amplifier
Electronic Crossover Network •
Line Outs for L/R Channels •
Bass Boost Circuit•
Tri-Mode Capable •
Gold RCA Inputs •
Bridgeable at 4 Ohms •
2 Ohm Stereo Stable•
Advanced Protection Circuitry •
Stify Regulated PWM-Type Power Supplies •
Variable Input Level Controls for Each •
Pair of Channels
Frequency Response: 15Hz-35kHz •
Variable Low Pass Filter Control: 40Hz~350Hz•
Variable High pass Filter Control: 40Hz~3kHz•
Variable Bass Boost Control: 0dB-6dB-12dB (SW)•
High-Efciency, Heavy Aluminum Heatsink •
Power Protection LED Indicators •
Soft Turn On/Off•
S/N Ratio: >95dB •
2 x 875 Watts RMS at 4 Ohms •
2 x 1750 Watts MAX at 4 Ohms •
2 x 1575 Watts RMS at 2 Ohms•
1 x 3500 Watts MAX at 4 Ohms MONO•
Fuse: 25A x 3•
9.33’’(W) x 2.56’’(H) x 15.76’’(L)•
VBP231 1000 Watts 2 Channel High Power MOSFET Amplifier
Electronic Crossover Network •
Line Outs for L/R Channels •
Bass Boost Circuit•
Tri-Mode Capable •
Gold RCA Inputs •
Bridgeable at 4 Ohms •
2 Ohm Stereo Stable•
Advanced Protection Circuitry •
Stify Regulated PWM-Type Power Supplies •
Variable Input Level Controls for Each Pair of •
Channels
Frequency Response: 15Hz-35kHz •
Variable Low Pass Filter Control: 40Hz~350Hz•
Variable High pass Filter Control: 40Hz~3kHz•
Variable Bass Boost Control: 0dB-6dB-12dB (SW)•
High-Efciency, Heavy Aluminum Heatsink •
Power Protection LED Indicators •
Soft Turn On/Off•
S/N Ratio: >95dB •
Fuse: 20A x 2•
2 x 250 Watts RMS at 4 Ohms •
2 x 500 Watts MAX at 4 Ohms •
2 x 450 Watts RMS at 2 Ohms•
1 x 1000 Watts MAX at 4 Ohms MONO•
9.33’’(W) x 2.56’’(H) x 9.85’’(L)•
VBP241 1600 Watts 2 Channel High Power MOSFET Amplifier
Electronic Crossover Network •
Line Outs for L/R Channels •
Bass Boost Circuit•
Tri-Mode Capable •
Gold RCA Inputs •
Bridgeable at 4 Ohms •
2 Ohm Stereo Stable•
Advanced Protection Circuitry •
Stify Regulated PWM-Type Power Supplies •
Variable Input Level Controls for Each •
Pair of Channels
Frequency Response: 15Hz-35kHz •
Variable Low Pass Filter Control: 40Hz~350Hz•
Variable High pass Filter Control: 40Hz~3kHz•
Variable Bass Boost Control: 0dB-6dB-12dB (SW)•
High-Efciency, Heavy Aluminum Heatsink •
Power Protection LED Indicators •
Soft Turn On/Off•
S/N Ratio: >95dB •
2 x 400 Watts RMS at 4 Ohms •
2 x 800 Watts MAX at 4 Ohms •
2 x 720 Watts RMS at 2 Ohms•
1 x 1600 Watts MAX at 4 Ohms MONO•
Fuse: 25A x 2•
9.33’’(W) x 2.56’’(H) x 11.82’’(L)•
HRT Heritage 1’’ Silk Dome Tweeters
1’’ Silk Dome Tweeter •
High Density Neodymium Magnet •
Tri-Way Swivel Mounting System: Flush / Swivel / •
Surface or Angle Mount
50 Watts RMS / 100 Watts Peak •
SPL: 96dB @ 1W/1M •
Frequency Response: 1.4-24KHz •
Ferro Fluid Cooling•
vibe pro series amplifiers
Lanzarcopy.indd 32 11/24/2009 7:10:51 PM