Lars Thrane Iridium Certus LT-4100 User Manual

LT-4100 User & Installation Manual Rev 1.00 Web server
Lars Thrane A/S www.thrane.eu Page 104 of 129
Reset to factory default
The LT-4100 system supports reset to factory default. This reset functionality is only available via the web
server, see Figure 128. By pressing ‘Reset to factory default’ and acknowledging this reset, the LT-4100
system will configure all settings to default and remove all user data (e.g. Contact List, Call History, etc.).
The LT-4100 system will reboot once the factory reset has been affected.
NOTE: By ‘Reset to factory default’ the LT-4100 system will lose all settings configured and user
data will be lost. The system will be operational again once it has rebooted
NOTE: A factory default reset will configure the following display and audio settings:
Display: Mode = Day time and Brightness = 70%.
Audio: Speaker Volume = 80%, handset Volume = 60%, Ringer Volume = 80%, and
Key Beep = 40%.
Figure 128: Web server (Reset to Factory Default)

Lars Thrane Iridium Certus LT-4100 Specifications

General

Brand	Lars Thrane
Model	Iridium Certus LT-4100
Category	Conference System
Language	English