LaserPro Mercury - Page 26

M
M
M
E
E
E
R
R
R
C
C
C
U
U
U
R
R
R
Y
Y
Y
U
U
U
S
S
S
E
E
E
R
R
R
M
M
M
A
A
A
N
N
N
U
U
U
A
A
A
L
L
L
25
Upon the receipt of a complete file, LCD will show the following message for instance. Then
press START/STOP key, the engraver starts engraving or cutting.
If there is no file having been sent, the message will display as follows.
NOTE: Please refer to the flow chart of “Start to Operate”, page 16 .
ENTER
Accept and store the selection for setting up.
AUTO FOCUS
This key can only be operated under STOP condition. Press this key will move up the working
table until the engraving object touches the tip of the focus tool, then the table will move down
and stop in focus automatically.
Whenever you change a lens with different focal length, press Function key and go through the
process of “Select lens” . After changing the lens, press AUTO FOCUS key to save the new
focal length in memory. LCD will show as follows:
NOTE: 1. “0.0 mm” means the focus position is the Z-axis home position of the
Working table. Above this position the value is negative while below this
position the value is positive.
2. Whenever the motion system or working table has ever been adjusted by
a technical person, please press AUTO FOCUS key to get an initial position
before going through the function of “Tuning” (Auto focusing) to change the
focal length.
Arrow Keys
Move cursor on the display for selection or adjust the working table on Z position by pressing
the arrow keys of UP and DOWN.
File: # 1 file name
Speed: 70 % 00:00
Power: 40 % PPI: xxxx
DPI: 500
Wait until at least one complete
file is received, then press START
to start a job
Focusing
Then do setup or send a file
to start a job
0.0 mm
NOTICE:
To stop the motion of auto focus, please press either UP or DOWN arrow key. If you press
the key continuously
, working table will move up or down correspondingly.