LaserPro Mercury - I. INTRODUCTION; Safety and Precautions

M
M
M
E
E
E
R
R
R
C
C
C
U
U
U
R
R
R
Y
Y
Y
U
U
U
S
S
S
E
E
E
R
R
R
M
M
M
A
A
A
N
N
N
U
U
U
A
A
A
L
L
L
4
NOTICE:
1. In order to match Mercury driver’s color. Make sure your CorelDRAW V.11 or later the
“Color Management off” is disable. Please fallow the steps:
Tools
Color Management Color Management Off OK.
2. When operating with CorelDRAW V.11 or later version, please choose Layout
Page Setup Set From Printer.
3. When using the available artworks from the Clipart of CorelDRAW, to prevent the
hidden vector lines shown on your engravings. Please do as follows:
Choose a file from Clipart, go to Bitmaps
Convert to Bitmap, after converting
the file, go to Bitmaps
Mode Grayscale OK.