LaserPro Mercury - Page 51

M
M
M
E
E
E
R
R
R
C
C
C
U
U
U
R
R
R
Y
Y
Y
U
U
U
S
S
S
E
E
E
R
R
R
M
M
M
A
A
A
N
N
N
U
U
U
A
A
A
L
L
L
50
 Pitch Value & Shoulder Power Setting
The finished stamp will be a reversed image with engraved depressions and
ridges. Many of these ridges may be too thin and would break off or be unstable.
Creating pitch is a way to add support to the thin lines and ridges. The pitch value
setting allows you to adjust the width of the ridges. Broad pitch gives the
maximum amount of support for each ridge. Experiment with different pitch value
settings in order to produce the stamp that is best suited for your application. You
can specify the size into the pitch box under stamp mode and adjust the bar to
specify different laser power level for shoulder.