Laspaziale S8 DSP - Programming; Programming the Boiler Temperature; Programming Coffee Doses; Programming Hot Water Delivery for the Preparation of Infusions

17
LSI 090 - Rev. 00 - Ed. 04/2018
6. PROGRAMMING
Press and hold down the “P” key for 3 seconds to enter in Programming mode: the display will ash.
6.1 PROGRAMMING THE BOILER TEMPERATURE
Press the “+” key to increase the boiler temperature.
Press the “-” key to reduce the boiler temperature.
6.2 PROGRAMMING COFFEE DOSES
Hook the portalter with coffee in the 1st group on the right and press the key for 1 short coffee to begin pouring.
Once the cup contains the right amount of coffee, press the 1 short coffee key to nish pouring and to store this amount for all groups.
Repeat this process for the other three coffee doses.
To programme the 2nd - 3rd - 4th group to be different from the others, press the continued delivery key for the required group and
follow the procedure illustrated above.
6.3 PROGRAMMING HOT WATER DELIVERY FOR THE PREPARATION OF INFUSIONS
Press the “hot water delivery” key to start delivery of water.
Once the required amount of water is in the jug, press the same key to stop the ongoing delivery and save it to memory.
PROGRAMMING THE M.A.T. TEMPERATURE - optional (see page 22).
To exit from Programming mode, press the “P” key.
Once entered in Programming mode, the appliance exits automatically from this mode after 60 sec. from the last pressure on any key.
Take note!