Proline Kryomats
62 Starting up YAUE0007 / 2/26/2009
7.8.2 Selecting and starting the program (Start, Hold, Stop)
Here you will learn how to select and start a program that has already been created. If no program has
been created Ö 7.8.4 “Creating or modifying a program (Edit)”.
Command
− Programmer Program 1
− Open the device parameter menu via the
soft key Menu .
− With the cursor keys continue to:
¤ Programmer ¤ Program 1 .
− Confirm with the key .
− The submenu Status appears.
− Using the Status menu, the selected
program can be:
1. started Start ,
2. paused Hold ,
3. continued Continue or
4. terminated Stop .
In addition, the standby key stops the
programmer! (Pause operation).
After standby is deactivated, the programmer
goes on! Commands, which, depending on the
situation, cannot be executed, are not displayed.
Continue therefore only appears when Hold
has been activated.
− Once the start has been confirmed with
, Prog. 1 running appears at the
bottom.
Hel
Menu End T
set
T
fix
Pump
Settings
Graph
Clock
Programmer
Interfaces
Control
Limits
Program 1
Program 2
Program 3
Program 4
Program 5
Ramp function
Hel
Menu End T
set
T
fix
Status
Edit
Loops
Graph
Info
Start
Hel
Menu End Pro
.1 runnin
Status
Edit
Loops
Graph
Info
Hold
Stop
To Next Page
Loading...
Need help?
General
