Launch Creader Elite 2.0 BBA - Settings; Units of Measurement; Automatic Detection on Connect; Brightness

24
LAUNCH
7. Settings
7.1 Units of measurement
This option can set the measurement unit. Metric System and English System
are available.
7.2 Automatic detection on connect
This option enables you to determine whether to start an automatic VIN detection
once the tool is properly connected to the vehicle’s DLC.
7.3 Brightness
This item allows you to set the standby time and screen brightness.
*Note: Reducing the brightness of the screen is helpful to conserve the power of the tool.
7.4 Sound
This option lets you adjust the volume and other sound settings.
7.5 Network
The built-in WLAN module allows you to register the tool, update diagnostic
software & APK, and send email on a wireless network.
7.6 Time Zone
This option allows you to set the time zone.
7.7 Language
The tool supports multiple languages. You can use this option to change the
target language.
7.8 Workshop information
This option allows you to add a personalized tag on the diagnostic reports.
*Note: After you congured it, the system will append it on the report every time a report
is successfully generated.
7.9 Recovery
Use this item to reset this tool to the default factory setting.