iii
LAUNCH
Compliance Information
FCCID: XUJOCEX403
Any Changes or modications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in
a residential installation.
This equipment generates, uses, and can radiate radio frequency energy,
and if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment o and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit dierent from that to
which the receiver is connected.
- Consult the dealer or an experienced radio / TV technician for help.
The device has been evaluated to meet general RF exposure requirement.
The highest reported SAR for stand-alone and simultaneous transmission
exposure conditions are below the maximum value. End-users must
be informed of the operating requirements for satisfying RF exposure
compliance.
This device is in compliance with the essential requirements and other
relevant provisions of Radio Equipment Directive 2014/53/EU. The RF
frequencies can be used in Europe without restriction.
To Next Page
Loading...
