Launch X-431 ADAS PRO - Page 13

LAUNCH X-431 ADAS PRO Calibration Tool User Manual
9
No.
Description
A
Base support
To firmly fasten the beam lifter to balance the cross member and
calibration frame installed on the beam lifter. Equipped with four rolling
casters, it also provides the ability to move the tool anytime and anywhere.
See Chapter 3.2 for details.
B
Cross member
It is installed on the beam lifter and supports the calibration frame. To
obtain more accurate result, ensure the cross member is centrally
mounted on the the beam lifter.
See Chapter 3.4 for details.
C
Calibration frame
Here you will need different calibration patterns depending on the car
manufacturer. These are optionally available.
See Chapter 3.4 for details.
D
Radar kit
There are three main components to the standard radar kit: radar
reflector, magnetic laser and angular attachment plate. A corner reflector
(See Appendix) is also required if necessary.
See Chapter 3.7 for details.
*Note: Radar kit is required only when calibrating Radar-based ADAS.
E
3 Points Wheel Alignment clamp
It can be adjusted to best fit with the vehicle’s tyre. A laser module is also
provided for each wheel alignment clamp so that the vehicle can be
placed centred in front of and in parallel with the calibration tool more
efficiently.
See Chapter 3.6 for details.
F
Beam lifter
Connected to the AC outlet, it sits in the center of the base support and
controls the height of the calibration frame. A scale ruler is also available
on it for reading the height of the calibration frame.
See Chapter 3.3 for details.