Launch X-431 ADAS PRO - 5.2.2 Calibrating Rear & AVM Camera; 5.3 Calibrating Radar-based ADAS

LAUNCH X-431 ADAS PRO Calibration Tool User Manual
47
5.2.2 Calibrating the rear & AVM camera
No calibration tool is required for the calibration of the rear camera. User just needs to
choose the corresponding calibration pattern, and follow the on-screen instructions on
the diagnostic tool to place the calibration pattern to the desired position in rear of the
vehicle.
5.3 Calibrating Radar-based ADAS
X-431 ADAS PRO calibration system provides a Radar expansion kit for the calibration
of the radar-based Advanced Driver Assist Systems (ADAS). Compatible with the
systems used by VAG and on certain ADAS-equipped Mercedes-Benz models, it
extends the capability of the X-431 ADAS PRO calibration tool beyond just
camera-based systems.
Before proceeding this step, please make sure the following conditions must be met:
 Place the X-431 ADAS PRO calibration panel in front of the vehicle.
 Ensure the vehicle is stopped on even surface.
 Level gauge bubble of radar reflector is centred.
 Prepare the radar kit.
Fig. 5-10 (Magnetic laser)
Fig. 5-11 (Radar reflector)